Here are the build specs:Įmax MT2204 motors w/ BL Heli 12A ESCs (this is the Power Pack E from about 1.5 years ago) Maybe I'll just be stuck at 1.13 and an old version of CF configurator if I want to keep this thing in the air? Reverting back to 1.13 of Naze firmware + my old settings and all is well. In both cases the board indicates a solid red LED and a slow blinking green LED. No response from Taranis receiver here either. No response from the motors tab even if I use the ESC calibration sequence (master at full power, plug in battery, no audible esc noise)Ģ) When I am not connected to Cleanflight via USB and plug in a battery I get some an initialization beeps from the board, but not the ESCs. Unfortunately, I run into the same issue.ġ) When successfully connected to the board via USB I plug in a battery and get no audible initialization from the board OR escs. I get a programming failure if 'no boot sequence' is checked. I have tried to flash firmware with and without 'full chip erase' selected. I've confirmed that Firmware 2.3.2 is loaded to the board as indicated in the upper left of the CF banner.

After your comment, I've updated it to 2.4 and repeated the firmware flashing process. Is this board not compatible with the newest Cleanflight Firmware? Is there something I'm missing here? Any help would be greatly appreciated.

Battery is plugged in, props are off, Naze is successfully connected to CF I've tried pasting all of my 1.13 settings into 3.2 and this doesn't fix it. I get no ESC initialization beeps upon start up either. The motor control tab doesn't work and I also get no input from my Taranis. I'm able to flash the firmware fine (jumping boot pads, flashing in CF), however I get no motor control. Also, I'd like to do some PID tuning and Cleanflight configurator is telling me I need to upgrade the firmware in order to use the setup tab. It works fine with Version 1.13 firmware, but I'd like to upgrade to the newest (3.2) firmware since it's been a good 1.5 years since I worked on this thing. I'm reviving the guts of my old Versacopter with the Naze32 Rev 6 board. I apologize if this has been answered, but I've used the search function and have not found my answer

Cleanflight firmware hex file